<pre class="prettyprint lang-c">
// 'C' source line config statements
// CONFIG1
pragma config FOSC = INTOSC // Oscillator Selection (INTOSC oscillator: I/O function on CLKIN pin)
pragma config WDTE = OFF // Watchdog Timer Enable (WDT disabled)
pragma config PWRTE = OFF // Power-up Timer Enable (PWRT disabled)
pragma config MCLRE = OFF // MCLR Pin Function Select (MCLR/VPP pin function is digital input)
pragma config CP = OFF // Flash Program Memory Code Protection (Program memory code protection is disabled)
pragma config CPD = OFF // Data Memory Code Protection (Data memory code protection is disabled)
pragma config BOREN = ON // Brown-out Reset Enable (Brown-out Reset disabled)
pragma config CLKOUTEN = OFF // Clock Out Enable (CLKOUT function is disabled. I/O or oscillator function on the CLKOUT pin)
pragma config IESO = OFF // Internal/External Switchover (Internal/External Switchover mode is disabled)
pragma config FCMEN = OFF // Fail-Safe Clock Monitor Enable (Fail-Safe Clock Monitor is disabled)
// CONFIG2
pragma config WRT = OFF // Flash Memory Self-Write Protection (Write protection off)
pragma config PLLEN = OFF // PLL Enable (4x PLL disabled)
pragma config STVREN = OFF // Stack Overflow/Underflow Reset Enable (Stack Overflow or Underflow will not cause a Reset)
pragma config BORV = LO // Brown-out Reset Voltage Selection (Brown-out Reset Voltage (Vbor), low trip point selected.)
pragma config LVP = OFF // Low-Voltage Programming Enable (Low-voltage programming enabled)
// #pragma config statements should precede project file includes.
// Use project enums instead of #define for ON and OFF.
</pre>